Добро пожаловать
Вход / Регистрация

jeep grand cherokee ABS REPAIR (ABS MODULE)

Спасибо! Поделитесь с друзьями!

URL

Вам не понравилось видео. Спасибо за то что поделились своим мнением!

Sorry, only registred users can create playlists.
URL


Добавлено by Admin В Ремонт своими руками
9 Просмотры

Описание

READ INSTRUCTIONS FIRST PLEASE !!!!!!!

always take care in what you do , and make sure you know what you are doing whenever working on your cars brake system . read more below .......(BEFORE you start repairing )


this is only here to save you from paying huge bills for parts you do not need and wich can easily be repaired with litlle or no cost .
DO NOT TRY TO REPAIR YOU MODULE UNLESS YOU FULLY UNDERSTAND WHAT YOU ARE DOING !!!!

ALL AT YOUR OWN RISK !!!! (it isn't really that hard )

this is a little vid wich shows you how to repair the ATE abs module .
it's a simple repair which can be done without bleeding brakes or anything .

first you should remove the module from your car .
the module is bolted to the underside of the pump unit with 4 E5 little screws .
i used a small 4mm hex socket to remove this 4 screws .

the next step is to get the module open .
it might look easy with the clips on the side of the module , but they glued it together so you have to saw it open .
i used a litlle hacksaw , and sawd carefully along the edge of the cover .
you have to start sawing slightly higher than the steel bushings .
DON'T go to deep !!!! you'll damage everything !

when you are so lucky to get it open , go to the corner i point out in the video .
this is the corner where the pump connector is .

the problem is the positive pump terminal .
you should remove the silicone layer very carefull.
don't make any scratches or damage any component .

after you succesfully removed the silicone layer , you should clean the board a litlle to make sure your new solder properly connects to the board.

after you did this you can seal the module back together (or carefuly test it first )
i used ordinary household silicone to glue it shut .

this repair goes for all jeep grand cherokee vehicles from years 1995/6/7/8 with an ATE abs module .

the module number is 56027931
there are lots more modules with this problem but i don't know mumbers of that ones (post them in the comments please )

this also goes for jaquar cars volvos bmw and other cars and traction control systems on volvo !
you might wanna inspect al other solder points as well !

please comment if this worked for you .
feel free to ask any question about this repair.

no one can take any rights from this vid or sue me for anything .

Написать комментарий

Комментарии

Комментариев нет.
RSS